TrackAD

Airworthiness directives › 2021-04-02

AD 2021-04-02 Airworthiness Directives; Dassault Aviation Airplanes

Superseded. This directive was replaced by AD 2023-04-13. Work to the current one.
2021-03-30
2021-02-23
—
—
Airframe
2023-04-13

Models named: FALCON 2000EX. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Dassault Aviation Model FALCON 2000EX airplanes, certificated in any category, with an original airworthiness certificate or original export certificate of airworthiness issued on or before February 15, 2020.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

This paragraph restates the requirements of paragraph (i) of AD 2020-04-22, with no changes. For airplanes with an original airworthiness certificate or original export certificate of airworthiness issued on or before January 15, 2019: Within 90 days after May 4, 2020 (the effective date of AD 2020-04-22), revise the existing maintenance or inspection program, as applicable, to incorporate the information specified in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 12, dated November 2018, of the Dassault Falcon 2000EX Maintenance Manual. The initial compliance times for doing the tasks are at the time specified in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 12, dated November 2018, of the Dassault Falcon 2000EX Maintenance Manual, or within 90 days after May 4, 2020, whichever occurs later; except for task number 52-20-00-610-801-01, the initial compliance time is within 24 months after October 8, 2014 (the effective date of AD 2014-16-12, Amendment 39-17936 (79 FR 52187, September 3, 2014)). The term “LDG” in the “First Inspection” column of any table in the service information specified in this paragraph means total airplane landings. The term “FH” in the “First Inspection” column of any table in the service information specified in this paragraph means total flight hours. The term “FC” in the “First Inspection” column of any table in the service information specified in this paragraph means total flight cycles. Accomplishing the maintenance or inspection program revision required by paragraph (i) of this AD terminates the requirements of this paragraph.

Unsafe condition

This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. The FAA is issuing this AD to address reduced structural integrity of the airplane.

Affected ADs

(1) This AD replaces AD 2020-04-22, Amendment 39-19858 (85 FR 17487, March 30, 2020) (AD 2020-04-22). (2) This AD affects AD 2010-26-05, Amendment 39-16544 (75 FR 79952, December 21, 2010) (AD 2010-26-05).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1