TrackAD

Airworthiness directives › 2021-07-14

AD 2021-07-14 Airworthiness Directives; Yaborã Indústria Aeronáutica S.A. (Type Certificate Previously Held by Embraer S.A.) Airplanes

2021-04-20
2021-04-05
—
—
Airframe
—

Models named: EMB-135BJ, -135ER, -135KE, -135KL, -135LR, -145, -145ER, -145MR, -145LR, -145XR. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Yaborã Indústria Aeronáutica S.A. Model EMB-135BJ, -135ER, -135KE, -135KL, -135LR, -145, -145ER, -145MR, -145LR, -145XR, -145MP, and -145EP airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Agência Nacional de Aviação Civil (ANAC) AD 2021-02-02, effective February 26, 2021; corrected February 26, 2021 (ANAC AD 2021-02-02).

Unsafe condition

This AD was prompted by a report involving disconnection of a side arm strut from the right main landing gear (MLG); a subsequent investigation found that the side arm strut lower bearing was installed inverted on the airplane. The FAA is issuing this AD to address disconnection of the MLG side arm strut, which could prevent the MLG from being locked in the down position and possibly lead to loss of control of the airplane during take-off and landing.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1