TrackAD

Airworthiness directives › 2021-10-25

AD 2021-10-25 Airworthiness Directives; Airbus Helicopters

2021-07-06
2021-06-01
—
—
Airframe
—

Models named: EC130B4, EC130T2. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus Helicopters Model EC130B4 and EC130T2 helicopters, certificated in any category, with a tail rotor blade (TRB), obtained by forging, part number 350A33-3002-02, 350A33-3002-03, 350A33-3002-04, or 350A33-3002-05 installed.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2020-0187, dated August 21, 2020 (EASA AD 2020-0187).

Unsafe condition

This AD was prompted by a report of cracks and geometrical non-conformities of the TRBs; all cracks initiated in the drain hole area at the blade root section. The FAA is issuing this AD to address geometrical non-conformities of the TRBs, which could lead to crack initiation and consequent blade failure, and possible loss of control of the helicopter.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1