TrackAD

Airworthiness directives › 2023-16-04

AD 2023-16-04 Airworthiness Directives; Piaggio Aviation S.p.A. Airplanes

2023-08-30
2023-08-15
—
—
Airframe
—

Models named: P-180. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to the following Piaggio Aviation S.p.A. Model P-180 airplanes, certificated in any category: (1) Serial numbers (S/N) 1002, 1034 through 1234 inclusive, 3001 through 3014 inclusive, 3016, and 3018; and (2) S/N 1004 through 1033 inclusive if modified in accordance with Piaggio Service Bulletin 80-0142.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

(1) For purposes of this AD, “light corrosion” is corrosion that does not exceed a depth of 0.15 millimeter (mm) and does not extend beyond 1 square inch (645.2 square mm). (2) For purposes of this AD, a “new part” is a part with zero hours time-in-service (TIS).

Unsafe condition

This AD was prompted by a report of corrosion-induced cracking on the horizontal tail trim actuator (HTTA) fitting assembly. The FAA is issuing this AD to address structural failure of the HTTA fitting assembly. The unsafe condition, if not addressed, could result in loss of control of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1