TrackAD

Airworthiness directives › 2023-20-06

AD 2023-20-06 Airworthiness Directives; Airbus SAS Airplanes

2023-11-09
2023-10-05
—
—
Airframe
—

Models named: A330-202, A330-203, A330-223, A330-243, A330-841. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS Model A330-202, A330-203, A330-223, A330-243, and A330-841 airplanes, certificated in any category, manufacturer serial numbers 1780, 1782, 1784, 1785, 1805, 1823, 1835, 1845, 1847, 1854, 1859, 1864, 1872, 1877, 1878, 1882, 1888, 1932, 1936, 1964, and 1969.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2023-0054, dated March 14, 2023 (EASA AD 2023-0054).

Unsafe condition

This AD was prompted by a determination that the cold working process was partially performed on the circumferential joint at frame 58. The FAA is issuing this AD to address a partially completed cold working process on the circumferential joint at frame 58. The unsafe condition, if not addressed, could affect the structural integrity of the airplane and result in catastrophic failure.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1