TrackAD

Airworthiness directives › 2023-23-01

AD 2023-23-01 Airworthiness Directives; Airbus Helicopters

2023-11-29
2023-11-14
—
—
Airframe
—

Models named: EC130T2. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus Helicopters Model EC130T2 helicopters, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2023-0028, dated February 1, 2023 (EASA AD 2023-0028).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2023-0028.

Unsafe condition

This AD was prompted by a report of degradation of the rear transmission shaft bearing support and the determination that all the attachment rivets of the transmission shaft bearing support were sheared. Also, it has been reported that some attachment rivets of the transmission shaft bearing may have been painted over, preventing detection of this unsafe condition. The FAA is issuing this AD to address sheared attachment rivets of the transmission shaft bearing support. This condition, if not addressed, could lead to failure of the tail rotor drive shaft and subsequent loss of yaw control of the helicopter.

Affected ADs

This AD replaces AD 2022-01-05, Amendment 39-21893 (86 FR 74353, December 30, 2021) (AD 2022-01-05).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1