TrackAD

Airworthiness directives › 2024-16-11

AD 2024-16-11 Airworthiness Directives; Dassault Aviation Airplanes

2024-10-23
2024-09-18
—
—
Airframe
—

Models named: FALCON 7X. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Dassault Aviation Model FALCON 7X airplanes, certificated in any category. Note 1 to paragraph (c): Model FALCON 7X airplanes with modification M1000 incorporated are commonly referred to as “Model FALCON 8X” airplanes as a marketing designation.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2024-0076, dated March 19, 2024 (EASA AD 2024-0076).

Unsafe condition

This AD was prompted by reports of excessive thickness of the trailing edge of certain ailerons, which may affect the assembly of the rear spar with the lower and upper skins. The FAA is issuing this AD to address the thickness of the trailing edge of certain ailerons. The unsafe condition, if not addressed, could result in reduced structural integrity of the aileron.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1