TrackAD

Airworthiness directives › 2024-19-04

AD 2024-19-04 Airworthiness Directives; Airbus S.A.S Airplanes

2024-11-29
2024-10-24
—
—
Airframe
—

Models named: A350-941, -1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2024-0060R1, dated April 16, 2024 (EASA AD 2024-0060R1).

Unsafe condition

This AD was prompted by reports that engine nacelle anti-icing (NAI) forward bulkheads may have elongated locating holes. The FAA is issuing this AD to address elongated locating holes. The unsafe condition, if not addressed, could result in the fasteners, if loose, to vibrate and cause further elongation of the locating holes, which, eventually, can reduce the NAI performance. This condition, if not detected and corrected, could lead to the undetected loss of NAI protection on both engines, possibly resulting in loss of control of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1