TrackAD

Airworthiness directives › 2026-02-07

AD 2026-02-07 Airworthiness Directives; Airbus SAS Airplanes

2026-03-09
2026-02-02
—
—
Airframe
—

Models named: A350-941, -1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2024-0248, dated December 18, 2024 (EASA AD 2024-0248).

Unsafe condition

This AD was prompted by reports that certain lower torque links of the nose landing gear (NLG) were manufactured without bright shot peening; the omission of bright shot peening could result in reduced fatigue life of the parts. The FAA is issuing this AD to address omitted bright shot peening. The unsafe condition, if not addressed, could lead to failure of the nose landing gear, possibly resulting in damage to the airplane and injury to occupants.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1