TrackAD

Airworthiness directives › 2026-05-12

AD 2026-05-12 Airworthiness Directives; Airbus SAS Airplanes

2026-03-27
2026-03-12
—
—
Airframe
—

Models named: A350-941. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS Model A350-941 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2026-0018, dated January 26, 2026 (EASA AD 2026-0018).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2026-0018.

Unsafe condition

This AD was prompted by a report of a non-conformity in the serialization process of certain fuse pins and retaining pins installed in the main landing gear (MLG) trunnion block attachment, resulting in a non-unique combination of part number and serial number that could lead to a lack of traceability. The FAA is issuing this AD to address the lack of traceability, which, if not addressed, could result in incorrect tracking of part life, compromising continued airworthiness and structural integrity of the landing gear attachment, which could result in primary structural failure of the MLG attachment and collapse of the MLG.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1