TrackAD

Airworthiness directives › 2026-07-11

AD 2026-07-11 Airworthiness Directives; Airbus SAS Airplanes

2026-04-29
2026-04-14
—
—
Airframe
—

Models named: A350-1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS Model A350-1041 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2025-0117, dated May 19, 2025 (EASA AD 2025-0117).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2025-0117.

Unsafe condition

This AD was prompted by a report of a misalignment between a flap shaft and the catcher due to incorrect installation of the bracket supporting the catcher. The FAA is issuing this AD to address premature wear and possible rupture of the flap shaft under specific loads. This condition, if not addressed, could lead to a flap surface detachment, resulting in reduced control of the airplane and parts detached from the airplane, which could damage the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1