TrackAD

Airworthiness directives › 2026-10-01

AD 2026-10-01 Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes

2026-06-26
2026-05-22
—
—
Airframe
—

Models named: ERJ 190-100 ECJ. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Embraer S.A. (Type Certificate previously held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Model ERJ 190-100 ECJ airplanes, certificated in any category, as identified in Agência Nacional de Aviação Civil (ANAC) AD 2024-07-01, effective July 31, 2024 (ANAC AD 2024-07-01).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, ANAC AD 2024-07-01.

Unsafe condition

This AD was prompted by a manufacturing quality escape concerning certain overheat detection system (ODS) sensing elements. The FAA is issuing this AD to address defective sensing elements. The unsafe condition, if not addressed, could lead to an undetected thermal bleed leak that could start an ignition source in the fuel tank, damaging some electronic boxes and exposing the wing structure to high temperature gradients and unexpected thermal loads, which could result in reduced structural integrity of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1