TrackAD

Airworthiness directives › 2026-10-13

AD 2026-10-13 Airworthiness Directives; Airbus SAS Airplanes

2026-07-06
2026-05-29
—
—
Airframe
—

Models named: A330-201, -202, -203, -223, -243, A330-223F, -243F, A330-301, -302, -303. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS airplanes identified in paragraphs (c)(1) through (5) of this AD, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2025-0071, dated March 31, 2025 (EASA AD 2025-0071). (1) Model A330-201, -202, -203, -223, and -243 airplanes. (2) Model A330-223F and -243F airplanes. (3) Model A330-301, -302, -303, -321, -322, -323, -341, -342, and -343 airplanes. (4) Model A330-841 airplanes. (5) Model A330-941 airplanes.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2025-0071.

Unsafe condition

This AD was prompted by the identification of an incorrect shot peening application that was implemented in production. The FAA is issuing this AD to address the fatigue life of affected central windshield frames that might be lower than the certified value. This condition, if not addressed, could adversely affect the structural integrity of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1