TrackAD

Airworthiness directives › 2026-11-07

AD 2026-11-07 Airworthiness Directives; Bombardier, Inc., Airplanes

2026-07-20
2026-06-15
—
—
Airframe
—

Models named: BD-700-1A10, BD-700-1A11, Model BD-700-2A12. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Bombardier, Inc., Model BD-700-1A10, BD-700-1A11, and Model BD-700-2A12 airplanes, certificated in any category, as identified in Transport Canada AD CF-2025-41, dated August 20, 2025 (Transport Canada AD CF-2025-41).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Transport Canada AD CF-2025-41.

Unsafe condition

This AD was prompted by reports that certain seat frames were assembled without applying Loctite in certain locations of concern. The FAA is issuing this AD to address seat frames assembled without applying Loctite on certain screws that could lead to loss of structural joint integrity affecting safety equipment such as lap belt and seat backrest locking mechanisms. The unsafe condition, if not addressed, could result in reduced capability of the restraint system to protect an occupant.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1