AD 95-01-03 Airworthiness Directives; Dassault Aviation Model Mystere-Falcon 50 Series Airplanes

Models named: Mystere-Falcon 50 series. Read the applicability below — it usually turns on serial or part numbers too.

Model Mystere-Falcon 50 series airplanes having serial numbers 2 through 232 inclusive, certificated in any category. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must use the authority provided in paragraph (b) to request approval from the FAA. This approval may address either no action, if the current configuration eliminates the unsafe condition; or different actions necessary to address the unsafe condition described in this AD. Such a request should include an assessment of the effect of the changed configuration on the unsafe condition addressed by this AD. In no case does the presence of any modification, alteration, or repair remove any airplane from the applicability of this AD.

Required as indicated, unless accomplished previously. To prevent an electrical fire due to damage of the electrical wire bundles, accomplish the following: (a) Within 20 days after the effective date of this AD, measure the clearance between the electrical bundles in the left-hand cabinet and the counterbalancing actuator of the passenger door, in accordance with Dassault Aviation Alert Service Bulletin F50-A243 (F50-A39-1), Revision 1, dated November 10, 1994. (1) If the clearances are within the limits specified in the alert service bulletin, no further action is required by this AD. (2) If the clearances are outside the limits specified in the alert service bulletin, prior to further flight, reroute and clamp the wire bundles in accordance with the alert service bulletin. (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113. Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113. (c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. (d) The measuring, rerouting, and clamping shall be done in accordance with Dassault Aviation Alert Service Bulletin F50-A243 (F50-A39-1), Revision 1, dated November 10, 1994. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Falcon Jet Corporation, P.O. Box 967, Little Rock, Arkansas 72203-0967. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. (e) This amendment becomes effective on January 18, 1995. Issued in Renton, Washington, on December 22, 1994. Darrell M. Pederson, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 94-32036 Filed 12-30-94; 8:45 am] BILLING CODE 4910-13-U