TrackAD

Airworthiness directives › 98-06-30

AD 98-06-30 Airworthiness Directives; Raytheon (Beech) Model 400, 400A, 400T, MU-300, and MU-300-10 Airplanes

1998-04-24
1998-03-20
39-10408
97-NM-68-AD
Airframe
—

Makes named: beech, raytheon. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

The following models and series of airplanes, certificated in any category, equipped with AlliedSignal outflow/ safety valves, as identified in AlliedSignal Aerospace Service Bulletin 103570-21-4012, Revision 1, dated May 30, 1995: ------------------------------------------------------------------------ Model of airplane Serial Nos. ------------------------------------------------------------------------ 400................................... RJ-1 through RJ-65 inclusive. 400A.................................. RK-1 through RK-42 inclusive. 400T (military)....................... TT-4 and TT-19. MU-300................................ S/N A001SA through A091SA inclusive. MU-300-10............................. A1001SA through A1011SA inclusive. ------------------------------------------------------------------------ Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance

Required as indicated, unless accomplished previously. To prevent cracking and consequent failure of the outflow/safety valves, which could result in rapid decompression of the airplane, accomplish the following: (a) Replace the outflow/safety valve in accordance with AlliedSignal Aerospace Service Bulletin 103570-21-4012, Revision 1, dated May 30, 1995, or Raytheon Service Bulletin No. 2476, Revision II, dated June 1997, at the time specified in paragraph (a)(1) or (a)(2) of this AD, as applicable. (1) For Model 400, 400A, MU-300-10 series airplanes: Replace within 18 months after September 24, 1996 (the effective date of AD 96-17-10, amendment 39-9719). (2) For Model 400T (military) and MU-300 series airplanes: Replace within 18 months after the effective date of AD. (b) As of the effective date of this AD, no person shall install an outflow/safety valve, having a part number and serial number identified in AlliedSignal Aerospace Service Bulletin 103570-21- 4012, Revision 1, dated May 30, 1995, on any airplane unless that valve is considered to be serviceable in accordance with the applicable service bulletin. [[Page 13497]] (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA, Small Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO. Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO. (d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. (e) The replacement shall be done in accordance with AlliedSignal Aerospace Service Bulletin 103570-21-4012, Revision 1, dated May 30, 1995; or Raytheon Service Bulletin No. 2476, Revision II, dated June 1997. (1) The incorporation by reference of Raytheon Service Bulletin No. 2476, Revision II, dated June 1997, is approved by the Director of the Federal Register, in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. (2) The incorporation by reference of AlliedSignal Aerospace Service Bulletin 103570-21-4012, Revision 1, dated May 30, 1995, was approved previously by the Director of the Federal Register as of September 24, 1996 (61 FR 42996, August 20, 1996). (3) Copies may be obtained from AlliedSignal Aerospace, Technical Publications, Dept. 65-70, P.O. Box 52170, Phoenix, Arizona 85072-2170; or Raytheon Aircraft Company, Manager Service Engineering, Hawker Customer Support Department, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Small Airplane Directorate, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid- Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. (f) This amendment becomes effective on April 24, 1998. Issued in Renton, Washington, on March 11, 1998. Darrell M. Pederson, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 98-6952 Filed 3-19-98; 8:45 am] BILLING CODE 4910-13-U

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1