TrackAD

Airworthiness directives › 98-14-10

AD 98-14-10 Airworthiness Directives; Boeing Model 747-400, 757, 767, and 777 Series Airplanes Equipped with AlliedSignal RIA-35B Instrument Landing System Receivers

1998-07-22
1998-07-07
—
—
Airframe
—

Models named: 747-400, 757, 767, 777 series. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

Model 747-400, 757, 767, and 777 series airplanes; equipped with AlliedSignal RIA-35B Instrument Landing System (ILS) receivers, part number (P/N) 066-50006-0101; certificated in any category. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (e) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance

Required as indicated, unless accomplished previously. To detect and correct faulty ILS receivers, and to ensure that the flightcrew is advised of the potential hazard of performing ILS approaches using a localizer deviation from a faulty ILS receiver and also advised of the procedures necessary to address that hazard, accomplish the following: (a) Within 10 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to include the following statement. This may be accomplished by inserting a copy of this AD into the AFM. Any Instrument Landing System (ILS) or Localizer approach with only one operative AlliedSignal ILS receiver, P/N 066-50006-0101, installed is prohibited. Note 2: On Model 747-400 and 777 series airplanes, the existence of only one operative ILS receiver is indicated by the Engine Indication and Crew Alerting System advisory message, ``SNGL SOURCE ILS.'' On Model 757 and 767 series airplanes, failure of an ILS receiver is indicated by an ILS flag on the display of the Electronic Flight Instrument System when approach mode is selected. (b) Within 30 days after the effective date of this AD, accomplish the requirements of either paragraph (b)(1) or (b)(2) of this AD. (1) Perform a visual inspection of the 64 flight legs of the internal fault memory of all AlliedSignal RIA-35B ILS receivers, P/N 066-50006-0101, for fault codes ``Nl'' (glide slope antialias fault) or ``Nm'' (localizer antialias fault). Repeat the inspection thereafter at intervals not to exceed 64 flight cycles. If any fault code ``Nl'' or ``Nm'' is found, prior to further flight, replace the existing ILS receiver with a new or serviceable ILS receiver having the same P/N; or with an ILS receiver that has been modified to P/N 066-50006-1101 in accordance with AlliedSignal Electronic and Avionics Systems Service Bulletin M-4426 (RIA-35B-34-6), Revision 3, dated May 1998. Installation of an ILS receiver that has been modified (and the P/N converted) in accordance with the service bulletin constitutes terminating action for the inspection requirement of paragraph (b)(1) of this AD for that part. (2) Accomplish the actions required by paragraphs (b)(2)(i) and (b)(2)(ii) of this AD. (i) Revise the Limitations Section of the FAA-approved AFM to include the following statement. This may be accomplished by inserting a copy of this AD into the AFM. Category II and III operations are prohibited with AlliedSignal ILS receiver P/N 066-50006-0101 installed. (ii) Install a placard on the forward instrument panel of the cockpit in clear view of the pilots, which states: ``Category II and III operations are prohibited.'' (c) Replacement of all existing RIA-35B ILS receivers, P/N 066- 50006-0101, with RIA-35B ILS receivers that have been modified in accordance with AlliedSignal Electronic and Avionics Systems Service Bulletin M-4426 (RIA-35B-34-6), Revision 3, dated May 1998; and that have had their P/N's converted to 066-50006-1101; constitutes terminating action for the requirements of this AD. After the replacement has been accomplished, the AFM limitations required by paragraphs (a) and (b)(2)(i) of this AD may be removed from the AFM, and the placard required by (b)(2)(ii) may be removed from the cockpit. Note 3: Modification of all AlliedSignal RIA-35B ILS receivers, P/N 066-50006-0101, prior to the effective date of this AD in accordance with AlliedSignal Electronic and Avionics Systems Service Bulletin M-4426 (RIA-35B-34-6), dated December 1997; Revision 1, dated January 1998; or Revision 2, dated April 1998; is considered acceptable for compliance with the applicable action specified in this amendment. (d) As of the effective date of this AD, no person shall install on any airplane an RIA-35B ILS receiver, P/N 066-50006-0101, that has been found to be discrepant (that is, on which fault codes ``Nl'' or ``Nm'' were found during an inspection of the internal fault memory) unless the discrepancy has been corrected by modifying the ILS receiver in accordance with AlliedSignal Electronic and Avionics Systems Service Bulletin M-4426 (RIA-35B-34-6), Revision 3, dated May 1998. (e) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Seattle Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Seattle ACO. Note 4: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Seattle ACO. (f) Special flight permits may be issued in accordance with Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. (g) The modification, if accomplished, shall be done in accordance with AlliedSignal Electronic and Avionics Systems Service Bulletin M-4426 (RIA-35B-34-6), Revision 3, dated May 1998. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from AlliedSignal Aerospace, Technical Publications, Dept. 65-70, P.O. Box 52170, Phoenix, Arizona 85072- 2170. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. (h) This amendment becomes effective on July 22, 1998. Issued in Renton, Washington, on June 29, 1998. Vi L. Lipski, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 98-17914 Filed 7-6-98; 8:45 am] BILLING CODE 4910-13-U

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1