TrackAD

Airworthiness directives › 98-24-14

AD 98-24-14 Airworthiness Directives; Cessna Aircraft Company Models 340A and 414A Airplanes

1998-12-21
1998-12-02
39-10923
98-CE-111-AD
Airframe
—

Makes named: cessna. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

The following airplane models and serial numbers, certificated in any category, that are equipped with any WYE tube, part number (P/N) 9910299-25 or P/N 9910299-26, in the engine exhaust system: ------------------------------------------------------------------------ Model Serial numbers ------------------------------------------------------------------------ 340A................................. 215 through 1817. 414A................................. 1 through 1212. ------------------------------------------------------------------------ Note 1: This AD allows the aircraft owner or pilot to check the maintenance records to determine whether any WYE tube, P/N 9910299- 25 or P/N 9910299-26, has been installed in the engine exhaust system between May 8, 1998, and December 21, 1998 (the effective date of this AD). See paragraph (c) of this AD for authorization. Note 2: Cessna is considering issuing service information pertaining to this subject. This AD takes precedence over any existing or future service information on this subject. Note 3: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (d) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance

Required as indicated in the body of this AD, unless already accomplished. To detect and correct exhaust leaks caused by nonwelded exhaust system components, which could result in aluminum fuel lines bursting with consequent fuel spillage, an airplane fire, and/or an explosion, accomplish the following: (a) Prior to further flight after the effective date of this AD, remove from service any P/N 9910299-25 or P/N 9910299-26 engine exhaust system WYE tube. These P/N 9910299-25 or P/N 9910299-26 WYE tubes may be replaced with any of the following in accordance with the instructions in the applicable maintenance manual or other applicable FAA-approved document: (1) P/N 9910299-8 (for the P/N 9910299-25) or P/N 9910299-9 (for the P/N 9910299-26) WYE tubes; or (2) Any other FAA-approved engine exhaust system WYE tube that is not P/N 9910299-25 or P/N 9910299- 26. (b) As of the effective date of this AD, no person shall install, on any affected airplane, [[Page 66422]] any P/N 9910299-25 or P/N 9910299-26 engine exhaust system WYE tube. (c) The owner/operator holding at least a private pilot certificate as authorized by section 43.7 of the Federal Aviation Regulations (14 CFR 43.7) may check the maintenance records to determine whether any WYE tube, P/N 9910299-25 or P/N 9910299-26, has been installed in the engine exhaust system between May 8, 1998, and December 21, 1998 (the effective date of this AD). If one of these WYE tubes is not installed, the AD does not apply and the owner/operator must make an entry into the aircraft records showing compliance with this AD in accordance with section 43.9 of the Federal Aviation Regulations (14 CFR 43.9). (d) An alternative method of compliance or adjustment of the compliance times that provides an equivalent level of safety may be approved by the Manager, Wichita Aircraft Certification Office (ACO), 1801 Airport Road, Rm. 100, Mid-Continent Airport, Wichita, Kansas, 67209. The request shall be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO. Note 4: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from Wichita ACO. (e) Information related to this AD may be examined at the FAA, Central Region, Office of the Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri 64106. (f) This amendment becomes effective on December 21, 1998, except those persons to whom it was made immediately effective by priority letter AD 98-24-14, issued November 13, 1998, which contained the requirements of this amendment. Issued in Kansas City, Missouri, on November 24, 1998. Michael Gallagher, Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. 98-32045 Filed 12-1-98; 8:45 am] BILLING CODE 4910-13-U

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1